What the 0.8 ohm mesh pod does to your flavour
The 0.8 ohm mesh version of the XROS pod is not a flavour you buy in a bottle, it is a flavour engine you fill yourself. That distinction matters, because the coil inside these pods is the single biggest reason two people vaping the same e-liquid can get wildly different results. A 0.8 ohm mesh strip runs warmer and pulls more air than the tighter 1.0 ohm and 1.2 ohm XROS pods, so it tends to open a liquid up rather than pinch it down. Sweetness comes forward, top notes get room to breathe, and the whole draw feels rounder and more generous on the tongue.
Think of it as the difference between sipping a cordial through a thin straw and drinking it from a proper glass. The wider mesh surface heats more juice per puff, which is why bold profiles, menthols and layered desserts usually taste fuller through the 0.8 ohm pod than through the more restrictive options. If your e-liquid has ever felt a little flat or muted, moving it into this coil is often the fix.
Taste profile: what a 0.8 ohm mesh draw actually feels like
On the first inhale, a fresh, well primed 0.8 ohm mesh pod delivers an immediate hit of the liquid's leading note with barely any delay. Because the mesh saturates quickly, there is no thin warm-up phase where the flavour lags behind the draw. A strawberry reads as bright and jammy from puff one, a tobacco reads nutty and toasted, a mint arrives cold and sharp. The airier draw means you get a slightly softer, less dense inhale than a tight MTL pod, closer to a relaxed restricted draw.
Through the middle of the vape, this coil shows its strengths. The extra warmth teases out the deeper, rounder layers of a flavour that cooler coils tend to leave sitting underneath. Custards turn creamier, red fruits gain a cooked, syrupy depth, and bakery notes pick up that just-out-of-the-oven warmth. Vapour production is noticeably fuller than the 1.2 ohm pod, so the flavour carries on more cloud and coats the palate rather than skating over it.
On the exhale, the 0.8 ohm mesh leaves a warmer, longer aftertaste. Sweet liquids linger pleasantly, menthols leave a clean cooling trail, and drink-style flavours keep a little fizz on the lips. It is a satisfying finish rather than a clinical one, which is exactly what most people who choose this resistance are after.
Who this pod suits and when to reach for it
The 0.8 ohm mesh pod is the natural home for anyone who has drifted away from cigarette-tight draws and wants something a bit more open and flavourful without moving to a big sub-ohm device. It rewards higher-VG liquids and shines with all-day fruits, sweet menthols, drinks and desserts. It is a great choice for evenings on the sofa, long car journeys and slow social vaping, where you want each puff to be an event rather than a quick top-up.
- Best for: fuller flavour, warmer vapour and roomier draws.
- Ideal liquids: 50/50 to higher-VG fruit, menthol, dessert and drink blends.
- Nicotine: nic salts up to the UK limit of 20mg/ml suit lower-nicotine users well here, since the warmer, more generous draw already delivers plenty of throat presence.
How it compares, and what to rotate to keep your palate fresh
Against the 1.0 ohm and 1.2 ohm XROS pods, the 0.8 ohm mesh trades a tight, cool, high-nicotine MTL feel for warmth, volume and a more expressive flavour. If you love a sharp, cigarette-like draw and higher-strength salts, the tighter pods still have a place. If you want your juice to taste as loud as possible, this is the pod to load.
Because a warm, sweet coil can dull your senses over a long day, rotation keeps every puff tasting deliberate. Pair a rich dessert or custard in this pod with a crisp menthol or a sharp citrus in a second pod, and switch between them. That contrast resets the palate and stops any single flavour from turning into background noise. Keeping two or three of the four pack dedicated to different profiles is the easiest way to get the most from a multipack.
Getting the truest taste from it
Prime a new pod before its first use. Add a couple of drops of liquid directly onto the exposed mesh, fill the pod, then let it stand upright for five to ten minutes so the wicking cotton soaks through. Take two or three gentle primer puffs without firing hard, and the coil breaks in cleanly with no dry, scorched first draw.
Flavour is at its best in the first day or two after filling. Sweet, dark and heavily coloured liquids gunk mesh faster than pale fruits and menthols, so if a pod starts tasting muted or slightly burnt, that is the coil telling you it is spent rather than a fault with the liquid. Storing filled pods upright, away from heat and sunlight, keeps the flavour stable and stops leaking around the seals.
Coil life, value and who should skip it
Realistic pod life depends heavily on what you vape. Clear menthols and light fruits can keep a 0.8 ohm mesh pod tasting sharp for a week or more, while thick dessert and heavy sweetener blends may dull it in a few days. A four pack is designed to be a rolling supply, so you are never left without a fresh coil when flavour starts to fade. Swapping to a new pod the moment taste drops off is the single biggest upgrade most people can make.
Who should skip it? Anyone chasing the tightest possible cigarette draw with high-strength salts will usually prefer the higher-resistance XROS pods, which run cooler and stretch a small amount of high-nicotine liquid further. Very light vapers who take only occasional puffs may also find the warmer coil uses liquid a touch faster than they expect.
Reading airflow as a flavour dial
One thing many people miss is that a 0.8 ohm mesh pod responds strongly to how you draw. Sip it slowly and gently and you concentrate the flavour, letting the mesh linger on the liquid and pull out the deeper notes. Pull harder and faster and you get a cooler, airier, more vapour-forward hit that spreads the flavour thinner across a bigger cloud. Neither is wrong, they simply suit different moods, and it is worth experimenting with both on the same fill to find where a particular liquid tastes its best.
Where this coil really earns its place is with menthol and ice blends. The warmer running temperature stops a cold flavour from feeling thin or clinical, so a menthol comes through crisp on the exhale while keeping a bit of body underneath. The same logic applies to spiced and drink flavours, where the extra heat wakes up notes that a cold, tight coil would leave buried.
Flavour FAQ
Does the 0.8 ohm pod really taste different from the 1.2 ohm one?
Yes, noticeably. With the same liquid, the 0.8 ohm mesh runs warmer and airier, which brings sweetness and depth forward and produces more vapour. The 1.2 ohm pod is cooler and tighter, favouring a sharper throat hit and stronger nicotine feel over sheer flavour volume.
Which e-liquids taste best through this coil?
Sweet and layered profiles gain the most. Ripe fruits, custards, bakery blends, cola and other drink flavours, and sweet menthols all open up beautifully. Very thin, high-PG liquids can taste a little harsh in a warmer coil, so a balanced 50/50 or higher-VG mix usually delivers the smoothest, truest result.
Why has my flavour suddenly gone dull or slightly burnt?
That is almost always a tired coil rather than a bad batch of liquid. Mesh gradually clogs with residue from sweeteners and dark flavourings, muting taste before it turns harsh. Fit a fresh pod from the pack and the original clarity returns straight away.
Can I switch flavours in the same pod?
You can, but the previous liquid will leave a ghost in the wick, so a bold menthol followed by a delicate custard will taste muddled for a while. If flavour purity matters to you, dedicate each pod to one profile. With four in a pack, keeping separate pods for fruit, menthol and dessert is easy and gives you the cleanest taste every time.
